‘WELCOME HOME’ - With This Handy Coat Hanger
Add a personal touch to your hallway with this simple hanging solution
Print Page
Not you? Sign Out
Sign up to get the latest news on products and promotions. Register and review your products, share your thoughts with a community of DIY-ers, and be in with a chance to become a product tester.
Get Started Terms of Service
Have the board cut to size at your local DIY store when you purchase it. Sand your board for a softer look. Even if you don’t have many rough edges, sanding adds a finished, professional look to any piece.
Thoroughly sand your cut pieces of pallet. Use 3 strips of tape to separate the board into 4 sections. Then, trace “HOME” letter stencils onto wood with a pencil. Now, paint your wood carefully and stay outside of the stencil – you can paint over tape (carefully – avoid soaking tape with paint). Allow paint to dry fully and remove tape to reveal clean lines.
Do not start this step until your paint has dried completely! Drill 3 pilot holes for the hooks using your drill driver and a drill bit.
Also using your drill driver, screw in and secure the 3 coat hooks to your sign.
Using your drill, attach picture mounting brackets to back of sign. Be careful to measure appropriately or your sign may hang crooked! Find 2 studs in the wall and drill a screw into each stud. Attach wire to brackets and hang sign evenly.
‘WELCOME HOME’ - With This Handy Coat Hanger